FLOW
SPORPH
BRICK PATTERN
SUBD USED COMMANDS:
TAB for visibility
3dFace Append 3d face to subd
Stitch for merging Vertices
Insert SubD Edge Loop / Insert SubD Edge Ring
Crease / RemoveCrease works for both Vertices and Edges
SubDCrease - to add creases between 0 and 100 weight
Copy with Record History to modify in real time the copies
ExtractControlPolygon
ToSubD to transform the mesh into SubD
SubDLoft with sharp corners
Subdivide for incremental mesh subdivision
Double clicking edges and faces selects rings, it is possible to select from one edge to another edge, by providing the start end and in between Edges/Faces/EditPoints
UnweldEdge
MakeSubD firendly for curves that need to be extruded
zaha hadid high line: https://www.youtube.com/watch?v=tdFAJbzKRUQ&ab_channel=3DBeast
zaha hadid ROCA https://www.youtube.com/watch?v=toIhLpKbdZY&ab_channel=TheAdam
To align vertices use Pull
The Target boxes are achieved by offseting the slab curves and then extruding vertically
LAST STEP FOR VERTICAL CONTINUITY OF THE SUBD IS TO SNAP CLOSE VERTICES IN PLACE:
(try snap only naked vertices)
try again Sporph from Reference surface to Target Surface (extruded)
FULL FACADE, MIRRORED AT HALF, FLOW ALONG SURFACE